class 47 ETH cutaway headstocks
class 47/57 ETH headstocks 3d resin print. Which replace the original O gauge heljan ones on version 2 and 3 locomotives which have had the original bodywork modified with cutaway cowls. This started in the 1980's but became a standard modification in the 1990's. These have the Vacuum pipe missing so this needs removing from the original donor locomotive ones. These do not include the Buffer heads, springs and retaining clips and are sold as seen. These are also mainly for non snowplough fitted ones as they have the bufferbeam steps.
Class
47/4, 47/8 and 57/3 and 57/6
Scale
7mm Scale. 0 gauge.
Material
Beige resin 3d print
Fitting Instructions
A light sand with 400 grit sand paper will remove any fine print marks. Test fit on the loco, it is push fit. The tank is marked with, no.2 bogie end to orientate it on the tanks. Remove tank prime in a plastic primer then paint black to match the battery boxes. Pick out the dials in red with a white centre. The needle can be picked out with a black permanent marker. The tank can be glued on with a spot of superglue on each inner corner.