Class 47/8 long range fuel tank resin print
Class 47/8 long range tank Also to suit railfreight distribution class 47/0 and 47/3. Fits Heljan class 47 with battery boxes only . This high quality 3d resin print fits around the existing battery boxes and is designed so you don't have to remove plastic module from the model (the screws are buried under the motors and are a pain to get out). This kit isn't the same as the class 47/7 as it doesn't have the balance pipe.
Class
47/0, 47/3, 47/8
Scale
7mm Scale. 0 gauge.
Material
Grey resin 3d print
Fitting Instructions
A light sand with 400 grit sand paper will remove any fine print marks. Test fit on the loco, it is push fit. The tank is marked with, no.2 bogie end to orientate it on the tanks. Remove tank prime in a plastic primer then paint black to match the battery boxes. Pick out the dials in red with a white centre. The needle can be picked out with a black permanent marker. The tank can be glued on with a spot of superglue on each inner corner.